Woman Turns Three Drinking Straws Into a Christmas Ornament With Just a Needle and Thread
Three drinking straws, a needle, and thread don’t sound like enough to make a Christmas tree ornament. But when the straws are cut into short sections and connected, they form a hanging geometric decoration without glue, tape, or special tools.
The finished ornament resembles a three-dimensional diamond, with red edges and an open center. It takes 12 straw sections to create the shape, with each piece measuring 2 inches and the thread holding the corners together.
Homedit contributor Brittney Smart shared the project using red drinking straws, heavy-duty thread, and a needle. The finished decoration hangs from a Christmas tree branch, with the straight straw sections forming a shape that looks far different from the original materials.
Red Drinking Straws Were Cut Into 2-Inch Sections
The project starts with red drinking straws cut into 12 equal sections, each measuring 2 inches. A ruler helps keep the pieces the same length so their ends meet when assembled.
Heavy-duty thread or fishing line holds the pieces together, with a needle passing through the hollow centers. The black thread shown in the process photographs makes the connections visible, while transparent fishing line can make them less noticeable.
Four Straw Pieces Form the First Diamond
Four sections are threaded onto a single length of string, leaving several inches free at one end. The ends are joined with a square knot, forming a diamond with four straight sides.
The knot needs enough tension to hold the straws together while leaving room to pass the thread through the joints during the next steps.
Two More Pieces Create the Next Section
Two additional straw sections are passed onto the thread and connected to the opposite corner of the first diamond. This creates another triangular section attached to the original frame.
The thread is wrapped around the joint to hold the new pieces in place without adding adhesive.
The Frame Expands With Another Pair of Straws
Another two straw pieces extend from the lower joint toward the opposite side. The new sections are joined at the upper corner, creating four triangular faces around the developing ornament.
The frame remains flexible at this stage because the side connections have not been completed.
Remaining Straw Sections Connect the Open Sides
The remaining four pieces are added one at a time between neighboring side joints. Each section forms a cross-connection that holds the triangular faces apart.
The thread passes through the existing straws to reach each connection point, reducing the need for separate knots at every corner.
Tightening the Thread Gives the Ornament Its Shape
As the side connections are secured, the frame takes on an eight-faced geometric form, with pointed ends above and below its widest section.
The thread is drawn through the upper joint and tied to hold the pieces in position. Too much tension can distort the straw connections, so the joints need to meet without bending the plastic.
A Thread Loop Turns the Prism Into a Hanging Ornament
A loop is tied above the top point for hanging the ornament from a Christmas tree branch. The finished piece uses all 12 straw sections, with no solid panels covering the open center.
Its three-dimensional frame keeps the red edges visible from different angles.
Twelve Straw Pieces Become a Diamond-Shaped Decoration
The assembled ornament has four corners around its center and two pointed ends, forming an octahedron. Thin thread joins the plastic pieces at the corners while the hollow center remains open.
Using transparent fishing line instead of black thread makes the connecting material less visible.
The Red Ornament Hangs From a Christmas Tree Branch
The red frame hangs beneath a green branch, with the open shape allowing the needles behind it to remain visible. Because the decoration is made from thin plastic straws, it weighs less than a comparable solid ornament.
A thread loop holds the top point against the branch, leaving the lower half suspended between the needles.
The Finished Ornament Needs No Glue or Tape
The final ornament has straight red edges, an open center, and a pointed diamond shape. Its structure comes from the thread passing through the straw sections rather than glue joining the ends.
The same method can be used with different straw colors, provided the pieces are cut to matching lengths.
Would you hang geometric ornaments made from drinking straws on your Christmas tree or choose traditional glass decorations?
Project and image credits: Brittney Smart / Homedit.











